Standart Pro SP Premier. A set of hardware with a 5, 6, or 7 m console

SP Premier Standart Pro (SP-5, SP-6, SP-7) — set of hardware for sliding console gates

Designed

The SP Premier Standart Pro set is designed for residential or entry-level industrial gates.

Gate weight: up to 500 kg;
Filling — ultra-light, light and medium weight:
- mesh,
- polycarbonate,
- metal sheet,
- aluminum or vinyl siding,
- metal panel;
Gate height: 1.9–2.5 m (depending on the filling).
- up to 1.8–1.9 m — with medium weight of the filling and maximum width of the gate opening,
- up to 2.5 m — with light filling and minimum gate opening.

SP Premier Standart Pro SP-5

SP Premier Standart Pro SP-6

SP Premier Standart Pro SP-7

Console beam, length 6 m, profile dimensions 60×70×3,5 mm, hot-rolled pickled metal, steel grade S235JR.
Roller carriages with 8 rollers, reinforced bearing series 301, one-piece carriage plate 10 mm thick.
Adjustable platforms, M14 studs, 5 mm metal.
Roller with bearing 201 series, material steel, housing steel, end cap for console with two rubber bumpers.
Upper holder for 4 rollers, double-layer rollers (inner cage frost-resistant polyamide, outer shell elastic plastic resistant to UV radiation, bracket.
Top catcher, 4 mm steel, rounded corners, wide shelves.
Bottom catcher with baffle, 4 mm steel, rounded corners, wide shelves, rubber baffle.
Steel plug for the gate beam, quick-release.

Quiet movement of the gate

Reasons for the quiet operation of gates with SP Premier Stantart Pro:
- Contact of the carriage bearings with the console in precisely calculated locations,
- Precise geometry of the console.

Wind torsion resistance

The gate does not «twist» in the wind thanks to the full counterweight and optional upper catchers. The gate is caught in the catchers under almost any conditions.

Standart Pro is available in extended versions such as Standart Trend та Standart.

Load resistance is provided by hot-rolled pickled and passivated structural steel grade S235JR.
Corrosion resistance (No significant corrosion of the internal cavity of the consoles for more than five years of intensive use), simplified storage and accelerated preparation for painting - due to the fact that the steel is passivated.
State certificate of conformity UA0.YT.081308-21.
Powerful carriages with 10 mm thick solid plates.
Safety is ensured by the upper and lower catchers with wide shelves made of 4 mm thick steel with rounded corners.
The durability of the hardware is also achieved thanks to the UV radiation resistant and low temperature resistant double-layer support rollers that do not damage the gate coating.
The internal cavity of the console is protected from dirt or snow by the front swivel roller with an assembled cap and the rear metal cap.
The reliability and durability of one of the key connections are ensured by the 20 mm thick carriage pin with 8 mm thick eyelets.
The branded markings on the kits, consoles and carriages protect against counterfeiting.